Fiber Instrument Sales’ OF1000UF visual fault locator identifies breaks and macro bends. It is for single- and multimode applications and is designed for fiber end identification. It features 1 mW fiber-coupled laser, 650 nm visible red light and a protective rubber boot.

AEMC’s CA7028 Wire Mapper Pro is a handheld structured cable-mapping and troubleshooting tester. It detects open circuit pairs, shorts, crossed wires, crossed pairs, reversed pairs, split pairs and shield faults. 

Fluke’s VR1710 single-phase power quality and voltage recorder is designed for detecting and recording power quality problems. It records voltage trends, dropouts and power quality to pinpoint the root cause and plugs directly into the mains power socket to capture data. 

AEMC’s ALS-1 AC line splitter increases the sensitivity of clamp-on current probes and clamp-on meters. It provides temporary separation of conductors (avoiding splitting of the line) to facilitate measurement of current. Two clamp positions are available: X1 for direct readings and X10 for actual readings multiplied by 10.

Teledyne Flir’s Extech 380941 200A AC/DC mini clamp meter features a small-diameter jaw designed to reach into small areas while providing 10mA resolution (DC) and very low current sensitivity. It can be used to troubleshoot home electrical, plant maintenance and other tasks.

Southwire’s compact 3-in-1 Cat 4 multimeter features a built-in noncontact AC voltage detector and LED flashlight. It has 10 measuring functions and the fuse automatically resets itself. It operates in temperatures between 0°F and 104°F.

AEMC’s AmpFlex AC current sensor permits measurements on conductors where standard clamp-on probes cannot be used. It can be installed in tight spaces, around cable bundles, around wide or large bus bars and wrapped around irregular shapes. 

Fluke’s 365 detachable jaw True RMS AC/DC clamp meter features a built-in flashlight for illumination and identification of wires. The compact design fits in users’ hands and can be operated while wearing protective equipment. The signal processing allows for use in noisy electrical environments while providing stable readings

Fluke’s 1770 series three-phase power quality analyzer automatically measures power and power quality parameters. More than 500 power quality parameters are captured by default, and the guided setup selects the right parameters for the system users are working on. Logged data is viewable, downloadable and shareable. 

Megger’s LT300 high current loop tester offers high current loop testing over a wide range of frequencies and supply voltages with a two-wire operation. It has a large clear display that aids visibility in poor conditions. It features a 16–400 Hz operation.

Cementex’s digital voltage phasing meter set is designed for measuring overhead and underground voltages. It detects 0–40 kilovolts and can be used on higher voltages up to 240 kV if used with additional pairs of extension resistors.