nVent’s K12 clip supports conduit to rod, wire or flange, and it can also be used for flexible metallic tubing, armored cable, portable cables, control tubes and communications cable. It is available for EMT, rigid, ENT, IMT, MC/AC and aluminum conduit.

nVent’s SCD1217QSC SCD multicable to deck clip provides support for low-voltage cables. It rotates 360 degrees to support various directional runs of cable. It features flared edges for cable protection, and no tools are required for installation. It is made of spring steel and can hold four cables.

RXL’s 1099-AL-01 splice connector is made of 6061-T6 aluminum. It is predrilled and serves as a splice connector and grounds the section of pathway. When the screws are tightened, the copper clips are sandwiched between the unpainted inside wall of the tube and the aluminum bar, which creates electrical continuity. 

Leviton’s cable-management clip aids in network management. The clip can support up to 24 cables and is designed to handle larger ones. The individual spring clips provide additional bend-radius control.

Burndy’s wire management clip is corrosion- resistant stainless steel that provides durability. The rolled edges are designed to help protect cable insulation from damage. The two snake tongue tabs anchor clips to module frames or purlins. It installs in a 90-degree orientation, and it is recommended for outdoor use.

Burndy’s Wiley ACC-F4F wire management clip is made of corrosion-resistant 304 stainless steel. It slides 90 degrees on to module frames of various thicknesses. It accommodates one to four PV cables up to 8 mm in diameter. The rolled edges are designed to help protect cable insulation from damage.2

Burndy’s ACC-F490 Wiley wire management clip is made of corrosion-resistant 304 stainless steel and accommodates one to four PV cables up to 8.0 mm in diameter. It slides 90 degrees onto module frames of various thicknesses. The rolled edges are designed to help protect cable insulation.