Hilti's cordless rotary hammer features a brushless motor and active vibration reduction that makes the tool less tiring to use. Active torque control stops the tool body from spinning uncontrollably if the drill bit jams. It is designed for chiseling and drilling into wood, metal or other materials. 

Ridgid’s 18V rotary hammer features a brushless motor. It is designed for less tool vibrations and fatigue and greater comfort. It features a selector to manually switch between rotary, drilling and chisel modes.

Milwaukee Tool’s cordless, rear-handle 7¹/₄-in. circular hand saw has an electric blade break, LED work light and magnesium guards to keep the user safe. It generates 15A corded power. It is designed with overload protection to prevent damage to the tool and battery.

DeWalt’s fully-automatic, .27 caliber, powder-actuated tool is supported with a compatible line of concrete, steel and I-beam fasteners. Together this low-velocity, direct-fastening system is designed for structural use in steel and concrete applications. Driving both 8 mm and .300-in. head fasteners ¹/₂–²⁷/₈-in. lengths as well as ¹/₄-in. threaded studs, it features automatic piston return and load indexing between fastenings.

DeWalt’s Max mixer/drill with the E-Clutch system is designed for mixing a variety of materials and high-torque drilling. The E-Clutch system senses tool motion and eliminates the torque by stopping the motor when binding is detected. It has a ¹/₂-in. keyed chuck that accepts hex or rounded mixing paddles, a three-position side handle, a variable speed trigger, a Bluetooth tag mount, chuck key holder, rear-handle mount and an LED light to illuminate the work space.

Burndy’s HPS-LWMAG hydraulic, long-reach pole cuts limbs and branches up to 13 in. in diameter. It features a 13-in. bar with an antikickback, narrow kerf, .325-in. pitch chain. It is available in lengths of 75 and 88 in.

Sulzer's MixPac MixCoat system is designed for applying rapid cure materials with an air compressor. The use of cartridges allow very small areas to be coated, and partially used cartridges can be recapped and reused, minimizing waste. The prefilled cartridges also protect the applicator from direct contact with unmixed material. 

Hilti’s SDS-max TE 60-ATC/AVR combihammer features active vibration reduction, active torque control and a detachable power cord that snaps out of the tool if too much tension is applied. Using the Hilti Connect App, contractors can access a comprehensive tool history and summary, send requests for a repair from the job site and more.

Ridgid‘s RE 6 electrical tool can be used with three interchangeable heads that rotate 360 degrees: the­ ­­­Swiv-L-​Punch knockout punch head, a dieless crimp head and a scissor cutter head with either copper/aluminum- or ACSR-wire blades. It has an LED light and automatic ram retraction.


FEIN’s oscillating MultiMaster and MultiTalent power tools with patented Starlock tool mount enables users to change accessories in less than 3 seconds. The more than 100 Starlock accessories are equipped with a recessed, 3-D mount with a rigid stainless steel holder.