Greenlee’s G10 Tugger 10,000-lb. two-speed puller can shift from high-speed/low-load pulling to low-speed/high-load pulling with a double-tap motion on the foot pedal control switch. The on-board force gauge provides visual communication of pulling force and speed changes. It is used for cable pulls requiring both high and low pulling loads.

iTOOLco’s Cordless Cannon’s built-in capstan switch automatically turns the puller on and off. Users tug on the rope to start the pull and slack off the rope to shut it down. It features overhead, underground or side handles. It has a wide-angle dual-head adjustment for precise puller alignment with conduit openings.

Emerson’s G1 Versi-Tugger is designed for pulls normally done by hand and can pull up to 68% faster compared to manual pulling. The handle provides balanced weight distribution to decrease strain. The five-position pulling head quickly attaches to 1/2- to 4-in. conduit. When used to spool pulling line or mule tape, the tapered capstan enables the spooled line to slide off in seconds with no need to reverse the drill.

Greenlee’s two-speed cable puller can shift from high-speed/low-load pulling to low-speed/high-load pulling with a simple double tap motion on the foot pedal control switch. It is designed for large and small cables up to 1,000 lbs. It features an on-board force gauge that provides visual communication of pulling force and speed changes.

Current Tools’ 6,000-lb. mobile cable puller features a four-wheel carriage for increased mobility and a built-in foot switch. It has a 8-ft. reach when fully extended and flat-free tires. The puller can be used on or off the carriage and has storage for all couplings.