Advertisement

Advertisement

Cutting in a New Wallbox, Drilling from a Crawspace

By Jun 15, 2000
generic image

Advertisement

Advertisement

Advertisement

You’re reading an older article from ELECTRICAL CONTRACTOR. Some content, such as code-related information, may be outdated. Find the most up-to-date content at ECmag.com/magazine/articles.

Where do I drill? Take the mystery out of this situation by using a 3-inch galvanized finish nail. Nail it in at an angle at the wall's edge, then look for it in the craw space. The silver color of the galvanized nail will be easier to find with a flashlight. Putting it in at an angle provides you with the right place to drill: It works every time. When finished, just drive the nail the rest of the way in and set with nail set. You will never see it again.

Advertisement

Advertisement

Advertisement

Advertisement

featured Video

;

New from Lutron: Lumaris tape light

Want an easier way to do tunable white tape light?

Advertisement

Related Articles

Advertisement