Legrand’s CabloBend adjustable mesh tray fitting has vertical and horizontal angle adjustability to 90 degrees to fit any configuration. It is available in three heights and seven widths. Rigidity clips are included to fasten sections together for added strength, and zero cutting is required.

iToolCo.’s 20-in. cable tray roller installs in three steps and secures into place with two locking underpins. It withstands cable pulling loads up to 2,000 lbs. Rollers glide smoothly, even when multiple cables are in the tray, and it can install above or below the tray. It can handle a variety of strut types and supporting members.

iToolCo.’s hook-type aluminum sheave enables users to change the direction of rope or cable while installing cable. Users can remove cable from either side once the pull is complete and then reset for the next pull in seconds without disconnecting the sheave from the hook assembly. It minimizes the need for cable splicing between termination points.

HellermannTyton’s IT18R9C2 cable tie features an identification plate that allows bundles to be easily marked and identified. Plates can be marked manually with a permanent marker or with a preprinted adhesive label. It can secure wire and cable harnesses.

Snake Tray’s 652 series raceway is designed to protect and house runs of control and power cables. It is used for cable and wire junction, distribution and termination where complete containment is required. The open design on one side allows for cables to be laid in safely along the entire run without pulling. All directional fittings are completed with factory-built...